WHAT ARE THESE BLACK STREAKS ON MY ROOF?
 |
FAQ
click here
OKLAHOMA ROOF RESTORE:
removes black streaks, algae, moss, mold
and
mildew from your roof, we don't just clean roofs, we can clean
anything that algae, moss, mold and mildew will grow on.
The
fact is that in most cases, the stains and streaks are a
form of algae or moss.
Roof algae commonly known as Gloeocapsa Magma, is a type
of algae that thrives in humid and warm climates and usually
appears first on the North Slope of the roof where shade is
prevalent and moisture tends to accumulate. The result is usually a
black streaked roof.
Roof moss, roof
algae and moss spores are carried by the wind,
birds, squirrels, etc.
If your roof is
currently clean, it likely won’t
stay that way, if other
houses in the area are already stained yours will get it.
|
STAINING, OR
STREAKING?
Are you having problems with staining or streaking on
your roof? You have come to the right place. We are specialists at
cleaning roofs. Removing stains from roofs siding and fences. Customers
are left with a clean, new looking house.
Why does my roof look so bad?
Pollution, trees, and jet exhaust are the first thing customers think of
when they see staining on their roof. They are often surprised to learn
that the problem is almost always a growth, such as algae, mold and
fungi, which feed on the minerals within the asphalt of their shingles.
Shingles today are made differently than the shingles of just 15-20
years ago. Shingles in the past were made up of a thick cellulose
(paper) mat, saturated with asphalt, and topped with granules. Most
shingles had an expected life span of 20 years. Growth didn’t occur on
these shingles until the latter part of their life span because the oils
would continually leach to the surface, preventing growth. In the final
years, the oils would become mostly dried and dissipated, and growth
would begin. It was often in the form of deep rooted systems, such as
those in the family of fungi commonly referred to as moss.
Most shingles today are made with a thinner layer of asphalt, separated
in the center, by a dense layer of fiberglass. Oils do not pass through
the layer of fiberglass. This is good for the bottom layer of asphalt.
It protects this layer from degrading, and helps shingles last longer.
However, the top layer of asphalt is very thin, and does not benefit
from leaching of oils from the bottom layer. In a short span of time,
this top layer loses its oils though weathering and evaporation, leaving
the remaining organic matter vulnerable to all sorts of growth. The
dense layer of fiberglass prevents most deep rooted growths, so most are
single cellular in nature, thus creating the look of a stain.
Will this problem damage my shingles?
Yes. The type of growth you have determines the amount of damage. The
least damaging are the algae and molds. These growths hold moisture,
which very slowly causes premature degrading of your roof. The worst growth we
encounter is lichen. We find it growing on roughly 20% of the roofs we
clean. Lichen is such a hardy feeder, it creates enough damage to the
roof, in as little as 3 years, so as to cause granules to fall off.
Customers often forget the visual damage growth causes to their roof.
Most roofs are replaced today due to the way they look. We are finding
many people are replacing their 25 year roofs in as little as 10 years
because they look so bad. Often a roof cleaning is all they need.
What about fungi resistant shingles?
Shingle manufactures have recently begun marketing shingles as algae and
fungi resistant. They achieve this by baking a micro thin layer of
copper sulfate on the outside of roof granular. Every time it rains, the
copper releases ions, which tend to kill growth spores. However, such
manufactures warranty the effects for only 10 years; where as the
shingles are warranted for 25-50 years. As the copper sulfate becomes
weathered away, the shingles begin to develop growth. Eventually, even
these shingles will need to be cleaned.
Why do most roofs have growth on the North side?
Ultra violet rays of the sun kill most growth spores from algae, mold,
and fungi. They also rapidly dry the surface after a rain, making it
impossible for them to feed.
What can be done to prevent growth after a roof is cleaned?
In the past, copper and zinc strips, installed on top of the shingles
along the ridge, were the only long term preventative available. Not
only did these methods not work well, but they also had a very short
effective period; especially in the case of zinc. Now
there is Roof Reviver, it can be applied to your roof to prevent algae,
mold, and fungi from growing on your roof, it will last for up to 24
months.
|